ATTENTION:
BEFORE YOU READ THE
PROJECT WORK, PLEASE READ THE INFORMATION BELOW. THANK YOU!
TO GET THE FULL
PROJECT FOR THE TOPIC BELOW PLEASE CALL:
08068231953,
08168759420
TO GET MORE PROJECT
TOPICS IN YOUR DEPARTMENT, PLEASE VISIT:
CONSTRUCTION OF 500
GALION (2250 LITERS) WATER RESERVOIR
ABSTRACT
The construction of the 500 gallous (2,250 litre) of water is a project which
has definite mathematical patterns. The choice of a cylindrical pattern of
design involved the application of mathematical deductions to analyse the size
of materials required.
The introductory and scope of the project emphasized the construction and
installation of a reservoir for water that could supply a community with water.
The tank’s installed and kept on a circular stand bass t avoid the reshape of
the bottom and of the tank.
The project studied the industrial
applications of the project with specific choices of material of
construction. The sequence of construction and the procedure of installation
suggested that the project has been completed for use in the storage.
The cost of fabrication of this
cylindrical type is cheaper than what is obtained in the open market. The cost
effectiveness of the construction makes the project very necessary; the
recommendation for improvement on future constructions.
TABLE
OF CONTENT
CHAPTER ONE
1.0
INTRODUCTION
1.1
SCOPE OF THE
PROJECT
CHAPTER TWO
2.0
types of reservoirs
2.1
industrial and domestic use of reservoir
2.2
materials of construction for different –
types of
reservoirs
2.3
design factors for
construction
CHAPTER THREE
3.0
procedure for construction of 500 –
gallons 2250
litres
3.1
installation procedure for the tank
3.2
cost
estimate/evaluation
CHAPTER FOUR
4.0
RECOMMENDATIONS
Conclusion
References
CHAPTER ONE
1.0
INTRODUCTION
Reservoirs are forms
of storages vessels.
Reservoirs are used
for different purposes ranging from use in the chemical industries to use in
the domestic homes of different chemical and physical properties others are
used for the storage of solids and semi-finished items.
They are reservoirs that are designed in the form of silos for the storage of
Agricultural equipments and even industries products.
Some reservoirs are sued in the cryogenic storages. Storage containers that are
used for storing cryogenic substances are designed 10 percent volume larger
than the substance so as to reduce rapid build up of pressure in the container.
The major problems of most reservoirs is leakage. Leakage usually result when
controlled resulting to the collapse of a section. It might equally result from
the rushing of a part of the container.
1.1
SCOPE OF THE PROJECT
The scope of the
project is the design of a 2.5m3 reservoir for holding water with
the following requirements;
i.
ability to withstand corrosion
ii.
cost should be comparable to what is obtainable in the open market
iii.
with the capacity to be used for hygienic water storage
iv.
should not be constructed of a material that can easily breakdown on any impact
of stress or be subjected to easy leakage of water
v.
should be installed on a support after construction.
AFFILIATE LINKS:
Comments
Post a Comment