ATTENTION:
BEFORE YOU READ THE
PROJECT WORK, PLEASE READ THE INFORMATION BELOW. THANK YOU!
TO GET THE FULL
PROJECT FOR THE TOPIC BELOW PLEASE CALL:
08068231953,
08168759420
TO GET MORE PROJECT
TOPICS IN YOUR DEPARTMENT, PLEASE VISIT:
Construction
of an industrial barrow
ABSTRACT
An Industrial barrow was produced which
would aid in conveying heavy materials in the laboratory and industrial set up.
It was made from mild steel that was
cut to dimension, made into shape and coupled to form the desired outstanding
barrow. Details are shown in chart (fig 1) containing the picture
representation.
Some of it’s dimensions are;
Bucket
- Area of 816.3 in2
Carriage
- Ø 1.3in x 63.65in
Stand
- 1.7in x 27in
Braces
- 1.5in x
12.5in; Ø 0.72 in x . 9.5in
Rim
- Ø 9.5in
Shaft
- Ø 2in x 10.3in
TABLE OF CONTENTS
CHAPTER ONE
Introduction
CHAPTER TWO
Literature review
CHAPTER THREE
Fabrication
procedure
Material of
construction
Design consideration
Construction procedure
Project drawing
Costing of standard wheel barrow
CHAPTER FOUR
Discussion
Precautions
Recommendations
Conclusions
References.
CHAPTER ONE
INTRODUCTION
One should be able to get familiarized
with the industrial barrow; its design, uses or function and areas of demand.
ILLUSTRIATION: An industrial barrow can
be classified under a second order lever; considering the L.E.F. (Load, Effort
and Fulcrum) positions. The weight or load being in between the effort
and fulcrum tells a typical second order lever, the effort being applied at one
and which is the handle of the barrow (helps one to lift the load);
The wheel being the fulcrum and the
bucket which serves as the load or weight (where the object would be placed
upon).
DESIGN:
The barrow was constructed having in mind the end of which it would be
used. Practically, the barrow is meant to carry loads which ordinarily
would be difficult to carry by ordinary human strength.
In this technology, it was found out
that is could to a considerable cheight, ease the labour to which one has to go
through in his daily activities especially when in the workshop or laboratory
when heavy loads are to be conveyed.
The design of the wheel barrow has
aided main to use a minimal amount of energy to convey heavy materials for
distants with the aid of its wheel which when not present would be impossible
or might involve more labour force when the barrow are not used. However,
due to its state of function. It is designed with metal steel so that it
can resist the force/weight applied to it. this is because of its
resistively, strength, rigidity and toughness.
FUNCTION/USES: The sole aim of
constructing on industrial barrow is its usage; to move materials or industrial
loads from one point of the factory / industry / laboratory to the other end or
from any of these to the other or another destination either for repair or
replacement. This in large extent, reduces cost, saves human strength,
time and for convenience.
AREAS OF
DEMAND: As the name implies, it is
basically an industrial equipment that aid in carrying out functions or tasks
which ordinarily cannot be attained if human effort well left to do to
alone. It is very vital that it be kept in proper use to achieve its
objectives. It is also capable of carrying rigid materials/objects which
if not used could result in the damage of the spinal cord in young adults
(youths). Thus; it helps to eradicate these problems to some certain
extent.
AFFILIATE LINKS:
Comments
Post a Comment